
Drone ID GPS – Module d’identification electronique pour drone
5 January 2021
GPS Here 3
16 January 2021Mini carrier board – PRO
250,00€
The Mini Carrier Board PRO is the ultimate setup to integrate The Cube autopilot into a drone It grants full connectivity in a very compact set of PCB Equipped with a PDB integrating two 5V3 voltage converters, current and voltage sensors as well as an offset shifter, it provides all the environment necessary for a complete setup.
Actual version : V1.0 Beta
Out of stock
The mini carrier board PRO is the most compact high end carrier board This combo ensures the distribution of signals and current.
The Pro version integrates a power distribution board and includes two 5.3v voltage converters, which provide power redundancy to the autopilot, current and voltage sensing This very compact set includes all the elements necessary to install a Cube and allows easy and clean mounting on all types of frames. It optimizes assembly and saves significant space.
The Airbot Mini carrier board PRO has been specially designed to allow the installation of a Pixhawk Cube on any drone. It offers complete connectivity in a reduced format:
-2 power ports
-RC input (PPM/S. BUS + 5V)
-Spectrum input + 3.3 v
-Serial ports: 1/2/3/4/5
– I2C + CAN
– GPS1 + GPS2
-PWM signal distribution for motors (up to 8)
-ect… (see user manual)
TECHNICAL SPECIFICATIONS:
Mini carrier board : (Version 1.4)
Dimensions : 50.5*57.5mm (1.98*2.26 inch)
Height with cube: 24.65 mm (EXCL. PSM + 2.75 mm approx)
Weight: 19gr (0.041 lb) (incl. connectors and PSM)
Mini Power Distribution Board :
Dimensions : 79*107mm (3.11*4.21 inch)
Weight : 37gr (0.081lb)
Max current : 100A
Power supply :
Weight : 9gr (0.019lb)
Output voltage : 5.3V
Max output current : 3A (5A peak tolerant)
Max voltage input : 50.2V (12S)
TOTAL weight : 76g (inclus entretoises)
DOWNLOADS :
Related products
-
Mini carrier board – PDB Combo
100,00€